Molding a permanent bend into a plastic worm? - plastic worm molds
I have a double standard in Worms plastic line that I go fishing with. Is there a way to do this without a form and is made from scratch on new? I thought I might be heating with a lighter and bend where I want, and cool. Who knows if it works?
Plastic Worm Molds Molding A Permanent Bend Into A Plastic Worm?
4 comments:
You can try this method:
Try to see it with a first worm, if it works for you.
Take a shallow dish on steel 12 "x 2" deep. Fill with corn starch and pack easily. Now take worm and put it in the way you want. Insert it into starch, but use up even with the peak strength. stop another pot, everything, until the cornstarch is completed by the company. Do not attempt to move in another direction, just a downswing. Place in the oven to 250 degrees. every 30 seconds. They want the worm is hot, but not melt. When the worm is hot, a little sentimental, remove and let cool at all. must be maintained once through cooling.
Preheat the bait in an oven or microwave (not too long)
Make a fast corner, then it is place in the fridge to get back to your trip:)
When I'm using floating worms, I just used a clip. Strait out and run it on the page, you can now bend as you want it.
trying to tie knots, and then heated. then let them sit for a while ..... perhaps a microwave .. I do not think
Post a Comment